EnoX® installation housing
EnoX® sealing foam frame
- Article no: 9350-99
- EAN: 4013456533011
- for fixing onto the EnoX® housing
- for sealing the moisture barrier to the housing
EnoX® installation housing
EnoX® housing for luminaires and other devices in ceilings and walls which are produced in a lightweight design with an air-tight building shell. Variable installation space when there is insufficient room to install electrics in the insulation level.
- Air-tight installation in line with GEG energy-saving ordinance.
- No additional installation level is necessary
- For ceilings and walls in renovated and new buildings
- Toolless cable and conduit entry
- Thermally-protected installation space 300 x 200 x 55 mm
- ECON® technology for air-tight and toolless insertion
- FX⁴ technology for fast cavity wall installation
Installation technology for low-voltage luminaires
Temperature profile for room temperature 23°C
Technical processing instructions / standards
- use only certified (EN 60598) luminaires which are suitable for direct installation on normally flammable materials
- only for insulation material with heat resistance > 250 °C
- use only tested heat-resistant cables (N2 GMH 2G) and temperature-resistant terminals (e.g. T100)
- use of electrical safety transformers up to 105 VA
- max. 35 W Cool-Beam, 50 W aluminium reflector, 6.6 W LED luminaires
Examples of use
Mounting instructions
The EnoX® housing is installed within or on the rafters using the timber or metal joist. In accordance with the cavity wall box principle, the housing is fixed to the joist or to an OSB panel using the FX⁴ strap fastening system. The cut-off moisture barrier is made air-tight again using sealing adhesive foil or the KAISER sealing foam frame. Before attaching the boarding, completely remove the moisture barrier foil from the housing interior. Together with the moisture barrier, the EnoX® housing now forms one unit to ensure air-tight installation in accordance with the GEG energy-saving ordinance.
